Home » Guides » How To Reset Throttle Position Sensor

How To Reset Throttle Position Sensor

The throttle position sensor (TPS) is one of the most important sensors in a car. It helps the engine know how much fuel to inject, and it’s responsible for operating the fuel injection systems. If it malfunctions, the engine may not run at its peak performance or may not start at all. In this article, we will show you how to reset TPS on a Toyota Prius. This process should be done every time you change the oil or when you do any other maintenance on your car. By following these steps, you can keep your engine running at its peak performance and avoid any unforeseen problems.

What is a Throttle Position Sensor?

A throttle position sensor (TPS) is a small device that detects the position of the throttle handle, and sends this information to the engine control module. When you start your car, the computer uses this information to adjust the fuel mixture so that your car runs at its best performance. A defective or worn TPS can cause poor fuel economy and even stalling. So it’s important to check it regularly and replace it if necessary.

How to Reset a Throttle Position Sensor

If your car has a throttle position sensor, it can sometimes become faulty. This can cause the throttle to not respond as it should when you press the pedal, and may even cause the car to stall. In order to fix this issue, you will need to reset the sensor.

To do this, first make sure your car is off and unplugged from the wall. Next, locate the throttle position sensor on your car and unscrew it from its mounting location. Once it is unscrewed, place it in a bowl of hot water for a few minutes to warm up. After it has cooled down, screw it back into place and reattach the mounting bracket. Finally, turn your car on and check to see if the problem has been resolved

What to do if the Throttle Position Sensor Does Not Work

If the throttle position sensor (TPS) does not work, you can reset it by following these steps: Disconnect the negative battery cable. Open the hood and locate the TPS connector. Remove the TPS. Reconnect the negative battery cable.