Home » Guides » How To Reset Throttle Body Sensor

How To Reset Throttle Body Sensor

Throttle body sensors are important parts of engine management systems. They help regulate engine speed, and when they fail, they can lead to a variety of problems. In this article, we will discuss how to reset a throttle body sensor, and what the consequences could be if it is not done correctly.

What is the Throttle Body Sensor?

The throttle body sensor is a device that monitors the air flow through the throttle body. If the air flow becomes too low or too high, it will send a signal to the engine management system to adjust the fuel and air mixture. This is important because it ensures that the engine receives enough fuel so that it can operate at its best performance.

How to Reset the Throttle Body Sensor

If you experience issues with your car’s throttle body sensor, resetting it may help. This procedure is performed by turning the ignition switch to the “Off” position, and then removing the negative battery cable. Next, disconnect the fuel line from the engine block and remove it from the vehicle. Finally, disconnect all connectors from the throttle body sensor.

How does resetting the Throttle Body Sensor affect my car’s performance?

Throttle Body Sensor (TBS) resetting is one of the common ways to improve car’s performance. Many people try this method when their car doesn’t perform as well as it used to. TBS resets itself by cycling through a set of points, which helps the engine learn better how to fuel and air/combustion mixture. If your car has been sitting for a while or you have recently changed the spark plugs or wires, then it may be time to reset the TBS.

You can reset your TBS by following these simple steps:
1. Open the hood and locate where the throttle body connects to the engine. There are usually two Phillips screws on each side of this connection point.
2. Remove both screws and carefully remove the throttle body assembly from the engine.
3. Make sure that all of the wiring connections are secure before replacing the throttle body assembly onto the engine. Replace both screws and position it back onto the engine so that you can reconnect any missing wiring connections.
4. Close the hood and start your car in neutral mode (with no gear engaged). Place your left foot on top of either pedal and hold down both pedals until your car starts, then release them quickly so that your car doesn’t stall out while it is trying to find its idle speed (the speed at which it will run without using power).
5. Put your right foot on top of either pedal


Sometimes when you’re driving your car, the throttle body sensor will start to act up. This can cause your car to hesitate or even stall when you try to accelerate. If this happens to you, there are a few things that you can do in order to reset the throttle body sensor and get your car back on the road. Hopefully this article has provided you with the information that you need in order to fix the problem. Good luck!