Home » Guides » How To Reset Transmission Adaptive Pressure

How To Reset Transmission Adaptive Pressure

Transmission adaptive pressure (TAP) is a technology that allows for vehicles to compensate for transmission irregularities. When your car feels like it’s “stuck in first gear,” this is most likely the result of a TAP issue. In this blog post, we will teach you how to reset your TAP and get your car moving again. By following our simple steps, you can avoid any costly repairs and get back on the road in no time.

What is Transmission Adaptive Pressure?

The transmission adaptive pressure (TAP) system is a variable valve timing system that helps optimize the fuel/air mixture in the engine for optimum performance. TAP works with the sensors in the engine to determine how much open Valve Time (OT) is necessary to provide optimum combustion and power output. When the engine reaches its operating point, TAP will retard the valves in order to maintain this operating point. If conditions change, TAP can momentarily advance or retard the valves in order to keep your engine running at its best.

How to Reset Transmission Adaptive Pressure

If you experience problems with your transmission, such as jerking or poor acceleration, you may need to reset the adaptive pressure. This is done by disconnecting the negative battery cable and reconnecting it while turning the ignition on and off several times.

What are the symptoms of Transmission Adaptive Pressure?

There are a few symptoms that can indicate that your transmission has gone out of adjustment. These include:
1. Poor acceleration or loss of power when shifting gears
2. Erratic or hard to control speed
3. Poor fuel economy
4. Rough ride

How to reset Transmission Adaptive Pressure on a Toyota Camry

To reset Transmission Adaptive Pressure on a Toyota Camry, follow these steps:

1) Open the hood and locate the transmission fluid level. It should be between the “Full” and “3/4” lines on the dipstick. If it is below the “3/4” line, add fluid until it is at this level.
2) Drive the car for about 10 miles (16 km) to allow the adaptive pressure to reset.
3) To reset the adaptive pressure permanently, remove the transmission pan cover and disconnect both TAP sensors (located near each gearshift). Reattach both TAP sensors by plugging them into two different connectors on back of gearbox.

How to reset Transmission Adaptive Pressure on a Nissan Altima

If you are experiencing difficulty with your Altima’s transmission, it might be time to reset the adaptive pressure. This is a relatively easy procedure that can help solve many common problems with your car’s transmission. The following steps will show you how to reset the adaptive pressure on your Altima:

1) Access the transmission by removing the front driver’s side wheel.
2) Disconnect and remove all of the bolts that hold the transmission mount in place. Be sure to save these bolts!
3) Carefully lower the transmission out of the car. You may need to use a vice grip or other supports to keep it straight as you do so.
4) Once it is out of the car, clean all of the old adhesive off of the Transmission Adaptive Pressure Sensor (TAPS).
5) Peel one end of the TAPS cover off and gently press it onto one end of the sensor. Make sure that it adheres well to both surfaces.
6) Repeat step 5 for each sensor on your Transmission Adaptive Pressure Sensor bracket. Be sure to orient them correctly so that they measure pressure in all four directions when they are installed into your transmission housing.
7) Install new bolts into their respective positions and tighten them down using a wrench, starting with bolt closest to the vehicle and working your way around until all bolts are tightened.


If you’re ever experiencing a problem with your transmission, it’s important to know how to reset the adaptive pressure. This involves overriding the computer that tells your transmission how much pressure to apply when downshifting or braking. By knowing how to do this, you can often fix your transmission on your own without having to take it into a mechanic. If you have questions about this process, don’t hesitate to reach out for help.