Home » Guides » How To Remove Windshield At Junkyard

How To Remove Windshield At Junkyard

If you find yourself stuck with a windshield that you can’t remove, then you may be in luck. There are a few methods that you can use to get the windshield off of your car, and we’ll outline them for you in this article. Simply put, there are a few basic steps that you need to take in order to remove the windshield: cut the metal, pry up the plastic, and pull. And remember: always use caution when working with machinery! Thanks for reading!

What You’ll Need

You’ll need a jack, a wrench, and some clamps.
First, put the jack under the car. Make sure that the lug nuts are tightened enough so the car doesn’t move while you’re working on it.
Then, use the wrench to remove the bolts that hold down the windshield. Be careful not to pinch your fingers!
Once they’re out, clamp both sides of the windshield in place so it doesn’t move around while you work with the screwdriver.
Now, use a Phillips head screwdriver to unscrew the screws that hold down the frame of the windshield. Be careful not to lose them!
Once they’re unscrewed, gently pull up on the frame of the windshield and set it free from the car. You can now replace it if needed.

How to Remove a Windshield at a Junkyard

If you live in a place where windshields are easilly tossed away in the junkyard, then this guide is for you. There are a few different ways to remove a windshield from a junkyard, but the most common is to use a hydraulic jack.

First, make sure that the jack has plenty of oil ready. Place the jack under the frame of the windshield and raise it until it’s level with the top of the car. Hold on to the frame and slowly lower the jack until it comes loose. Make sure to hold on to any screws that may be holding it in place!

Once the Jack has removed the windshield, use a crowbar or screwdriver to pry it off of the car. Be careful not to damage any wiring or brackets underneath. Once off, dispose of it properly or recycle it if possible.

Tips for Removing a Windshield

If you’re at a junkyard and need to remove a windshield, follow these tips:

1. Try to find a way to lever the windshield out from the inside. If you can’t do this, you may have to break it off.

2. Use a pry bar or a long piece of metal rod to try breaking the windshield loose from the inside. You may also need to use a screwdriver or an axe to chip away at the adhesive until it comes loose.

3. Once the windshield is free, use your hands or a large hammer to break it into small pieces that can be easily removed. Be careful not to hit your head while removing the glass!


If you’re looking to remove windshield at a junkyard, there are a few things you’ll need to remember. First, make sure that the area is clear of obstacles so that you can access the glass easily. Secondly, use caution while swinging your arm around — if the blade hits something hard, it could send shards flying. And finally, be sure to wear safety goggles and work gloves when taking down the windshield — the shards could cause serious injury if they hit your eyes or hands. Thanks for reading!