Flywheels are those pesky little engines that turn your car’s wheels. They’re also the parts that can be the most difficult to take care of, as they require regular attention in order to keep them running smoothly. One common issue that flywheels face is torque converter removal. If you ever experience problems with removing the torque converter from your flywheel, don’t worry—this guide will help you get the job done without any trouble.
Tools Required
Tools Required:
-Torque wrench
-Channel lock pliers
-Adjustable wrench
-Pipe fitting wrench
-Socket set (3/8, 1/2, 5/8, 11/16)
-Jigsaw or coping saw
-Hammer
-Nail or screwdriver
-Wire brush(s)
1. Verify that the flywheel is securely fastened to the vehicle’s engine. If your vehicle has an automatic transmission, make sure that the torque converter clutch is also properly connected and engaged. (See “How To Disconnect and Connect Torque Converter Clutch?” for more information.) If you are working on a car with a manual transmission, be sure to use the correct gear ratio for your toolset. A 3/8 inch wrench cannot replace a 1/2 inch wrench when using a gear reduction system on a manual transmission; likewise, using an incorrect gear reducer will result in damage to the transmission.
2. Remove the front wheel by removing the lug nuts and then unplugging the wheel from the axle. Remove any airbags before proceeding.
3. Loosen both bolts that hold on the torque converter housing cover plate. On most cars this will require a socket set (3/8 inch, 1/2 inch or 5/8 inch). Be careful not to drop these bolts into the engine bay while they are being loosened! Note: There may be additional bolts
How to Remove Torque Converter from Flywheel
If your car has a torque converter, it’s important to know how to remove it. The torque converter is a device that helps the engine change gears more quickly. It’s usually located on the exhaust side of the engine, and it connects the drive shaft to the automatic transmission.
To remove a torque converter from a flywheel, start by removing the bolts that hold it in place. Use a wrench to tighten these bolts slightly before turning them counterclockwise with an Allen wrench. Once they’re loose, use a dolly or jack to lift the converter off the flywheel. Beware of sharp edges on the flywheel!
Conclusion
If you’re having trouble removing the torque converter from your flywheel, there are a few things you can do to try and fix the problem. First, make sure that all of the bolts securing it to the engine are tight. Next, remove any debris or oil that might be obstructing its removal. Once these steps have been completed, use a wrench to loosen the torx bolt that holds on the torque converter hub and then twist it counterclockwise until it comes free. Finally, pull the torque converter Hub off of the flywheel and discard it.