Home » Guides » How To Remove Oil Pressure Sensor Electrical Connector

How To Remove Oil Pressure Sensor Electrical Connector

Many vehicles have oil pressure sensors that are used to detect engine malfunction and determine when to inject oil into the engine. If your car has a broken oil pressure sensor, you may not be able to start the car or it may have other problems. In this article, we will explain how to remove a oil pressure sensor electrical connector. Required Tools: -Hood release tool -10 mm socket wrench -5 mm socket wrench -T25 Torx bit -Flat head screwdriver -Needle nose pliers -Isopropyl alcohol -Quarter inch nutdriver Step One: Remove the Hood Release Tool The hood release tool is used to release the hood of your car without having to remove the screws located on either side of it. To do so, locate the two Phillips head screws closest to the edge of the hood and unscrew them. Next, use the hood release tool to unhook the clips located near the hinges on each side of the hood. Once these clips are free, pull up on the hood and pop it off of its mounts

What is an oil pressure sensor?

Oil pressure sensors are used to monitor oil pressure in a engine. When the oil pressure falls below a certain level, the sensor will activate an signal that tells the engine controller to change the RPMs or cut off the fuel supply. There are usually two oil pressure sensors located near the oil pan on the engine block. One sensor is on each side of the engine and they need to be replaced together as a pair if one goes out.

How does an oil pressure sensor work?

Oil pressure sensors are located on the engine block and they sense the oil pressure and relay the information to the engine control unit. The oil pressure sensor connector is usually a black, 18-pin connector and it’s usually located near the oil filter. If the oil pressure sensor fails, it can result in poor performance, lack of power, or an inability to start the engine. In order to remove the oil pressure sensor connector, you’ll need a T25 Torx bit and a 1/4 inch socket wrench. First, use the T25 Torx bit to remove the four screws that hold down the oil pressure sensor cover. Once you’ve removed the cover, use your 1/4 inch socket wrench to loosen the two Phillips head screws that hold down the connector. You can then disconnect the connector from its wiring harness by unscrewing it from its housing.

How to remove an oil pressure sensor electrical connector?

Oil pressure sensors are common on gasoline engines and are used to measure the pressure of the oil in the engine. When the oil pressure sensor malfunctions, it can cause poor fuel economy, loss of power, or even a blown engine. The oil pressure sensor electrical connector is often the first place where problems with the sensor arise. This guide will show you how to remove the electrical connector and repair or replace it if necessary.


If you’re having trouble removing the oil pressure sensor electrical connector on your car, here are a few tips that can help: start by using a narrow-tipped screwdriver to pry off the plastic cover. Next, use a wrench to unscrew the metal plug from the plastic housing. Finally, slide the new connector onto the metal plug and screw it back onto the housing.