Home » Guides » How To Remove Hubcap Without Tool

How To Remove Hubcap Without Tool

Hubcaps are a common sight on cars and trucks, but they can be a real pain to remove. If you don’t have the proper tool, it can be a very time-consuming process. In this blog post, we’ll show you how to remove hubcaps without any tools at all. Simply use your hands and patience to remove the hubcap without any help from outside sources. After you have learned how to do it, you will be able to remove hubcaps with ease on your next car or truck repair.


If you have a car with hubcaps, you may be wondering how to remove them without using a tool. There are several methods you can try.

The easiest way is to use your hands. Place one hand on the top of the hubcap and use the other hand to grab the rim of the wheel. Carefully lift the hubcap off of the wheel.

Another method is to use a lug wrench. Tighten the lug wrench around the circumference of the hubcap until it becomes tight but not too tight. Use caution not to damage the wheel.

The last method is to use a flat head screwdriver. Fit the screwdriver into one of the holes in the hubcap and slowly turn it counterclockwise so that it loosens from around the circumference of the hubcap. Once it’s loose, take it off of the wheel.


Removing hubcaps without a tool can be a difficult and time-consuming process. Some methods are easier than others, and some require more specialized equipment than others. In this article, we’ll highlight the three easiest methods for removing hubcaps without tools.


If you only have a flathead screwdriver, and your hubcap is glued on with a strong adhesive, you’ll need to remove the hubcap without a tool. Here’s how:

1. Locate the screw that attaches the hubcap to the wheel. This screw should be about 1 inch from the edge of the hubcap.

2. Place the flathead screwdriver against the back of the hubcap and turn it counter-clockwise until the screw comes out. Be careful not to strip or damage the wheel while removing the Hubcap!

3. If there are any other screws securing the hubcap to the wheel, remove them in a similar fashion.

Tips and Warnings

If you’re like most people, you probably cringe at the thought of having to remove a hubcap. The process can be quite tedious, and if you’re not careful, you can end up damaging your car. Here are some tips and warnings to help make the job a little easier:

1. Start by grabbing the wheel well cap with one hand and pulling it off of the wheel. Make sure that the lug nuts are still attached to the wheel.
2. If the hubcap is plastic, Pry it off by pressing down on one edge and rotating it around its circumference. If the hubcap is metal, use a flathead screwdriver to pry it off from the wheel.
3. Carefully inspect the area around the wheel for any nails or screws that may have been left behind, and remove them if necessary.
4. Use a Phillips head screwdriver to remove any screws that hold on the wheel hub itself (these may be hidden under protective tape). Be sure to note their location so that you don’t lose them!
5. Finally, use a socket wrench or multimeter (if needed) to remove the hubcap from the wheel. Be sure not to twist or torque it too tightly; this could damage it irreparably