Home » Guides » How To Change License Plate Light

How To Change License Plate Light

If you’ve ever driven in the dark, you know that one of the hazards of the road is trying to avoid cars with improper license plate lights. When these lights are not properly functioning, it can be difficult to see the letters and numbers on a license plate. Not only can this lead to accidents, but it can also be illegal. In fact, some states have laws against driving with improperly functioning license plate lights. Fortunately, there are ways to fix license plate lights and make them more visible. In this post, we will show you how to change a license plate light without having to take it into a mechanic or pay for an expensive repair.

What You’ll Need

If you’re thinking about changing your license plate light, here’s what you’ll need:

-A new license plate light
-An old license plate
-Two wire cutters
-Jack or a lug nut wrench
-Tape measure
-Paint or a marker
1. Start by removing the screws that hold the old license plate light in place. Be sure to label and save these screws! You’ll need them later. 2. Using the screwdriver, remove the old light bulb and wiring harness from the license plate. 3. Cut off the excess wires on the old light bulb and bundle them together with some tape. 4. Screw in the new light bulb and wiring harness into the same location as the old one. 5. Replace the screws that were removed in Step 1 and reattach the license plate light to your car!

How to Change License Plate Light

Step One: First, locate the light housing on your car. It is typically located near the rear of the vehicle.

Step Two: You will need to remove the light housing by unscrewing it and then removing it.

Step Three: Next, you will need to remove the old light bulb from the light housing. Use a Phillips head screwdriver to remove the old bulb.

Step Four: Then, insert a new light bulb into the light housing and screw it in place using a Phillips head screwdriver. Make sure that the terminal on the bulb is facing down.

Step Five: Finally, reattach the light housing to your car by screws and bolts that are included with your replacement kit.

Final Notes

If you’re looking to change the license plate light on your car, there are a few things you’ll need to do first.

You’ll need to get a new bulb and socket, as well as a new light cover. You can buy all of these items separately or in a kit.

To change the bulb, remove the old one by unscrewing it from the socket. Install the new bulb by screwing it into the socket. Slide the light cover over the bulb and screw it in place.

To change the plate light, first remove the old cover by unscrewing it. Install the new cover by screwing it in place. Then replace the bulbs by unscrewing them and installing new ones.